New Products  [more]

Extreme Flight Extra 300 EXP 85" - Orange/Blue
Extreme Flight Extra 300 EXP 85" - Orange/Blue
Rs.115,749.00  Rs.92,599.00
Save: 20% off
Extreme Flight Laser V2 EXP 74" - Red
Extreme Flight Laser V2 EXP 74" - Red
Rs.86,249.00  Rs.68,999.00
Save: 20% off
Extreme Flight Extra 300 EXP 85" - Yellow/Red/Blue
Extreme Flight Extra 300 EXP 85" - Yellow/Red/Blue
Rs.115,749.00  Rs.92,599.00
Save: 20% off


Multiplex Easy Glider Pro with Spinner Kit

  • Shipping Weight: 10lbs
  • Manufactured by: Multiplex


Sold Out
The EasyGlider PRO is based on the popular and proven Easy-Glider and EasyGlider electric.
The model’s flying characteristics are just right for the beginner, although this by no means implies that the more advanced pilot won’t enjoy it - quite the contrary. If you are an expert you will soon discover that the EasyGlider PRO behaves like a much
bigger model, and its performance is also far better than you might expect.

Construction: Elapor foam to resist damage, white in color
Wings: Two piece with fiberglass wing joiner
Spinner: Elapor foam 2.2" (55mm) diameter
Aileron Control: Dual servo
Control Surfaces: Elevator, rudder and ailerons
One Multiplex Easy Glider Pro with decal sheet, foam spinner, wing
joiner, pushrods, hardware and illustrated instruction manual
Radio System: 4-channel with micro receiver
Servos: Two micro size for elevator & rudder
Two nano size for ailerons
Servo Extensions: Two 16" (200mm) for aileron servos
Y Harness: For aileron servos
Battery: at least 2100mAh
Battery Charger: LiPo compatible
The Brushless Motor Power Pack (MPUG3226) is required
Building and Field Equipment: Medium viscosity regular (NOT styrofoam
safe) CA glue and activator, see COMMENTS
Wingspan: 72" (1828mm)
Length: 44" (1117.6mm)
Flying Weight: 28.5oz (810g) with standard power system
Wing Loading: 6.5 oz sq ft (20 g sq/dm) with standard power system
Wing Area: FAI approx. 645 sq in (41.67 sq dm)
Airfoil: Semi symmetrical
CG (Center of Gravity): 2.7" (70mm) from leading edge at wing root
measured at fuselage side
Control Throws-
Elevator, Up and Down: 0.31-0.39" (8-10mm)
Rudder, Left and Right: 0.59-0.79" (15-20mm)
Ailerons, Up: 0.59" (15mm)
Down: 0.24" (6mm)
Spoilers-Both Ailerons Up: 0.79" (20mm)
Spoiler Mixer (Elevator Trim Compensation): 0.16" (4mm)
This model is NOT made of styrofoam and it is not possible to glue
the material using white or epoxy glue. Medium CA glue used with an
activator is the only method of gluing recommended by the

This product was added to our catalog on Thursday 23 December, 2010.

Manufacturer Info

Who's Online

There currently are 21 guests online.
Copyright © 2021 RCDhamaka. Powered by RCDhamaka