New Products  [more]

Carbon Fibre 3K Sheet 250mm x 100mm x 1mm
Carbon Fibre 3K Sheet 250mm x 100mm x 1mm
Rs.952.54  Rs.761.86
Save: 20% off
SVMFG M3001x1 4-14S HYB BEC MADE IN INDIA
SVMFG M3001x1 4-14S HYB BEC MADE IN INDIA
Rs.4,500.00  Rs.3,600.00
Save: 20% off

Manufacturers

RFD868ux-IND Modem Bundle

  • Shipping Weight: 2lbs
  • Manufactured by: RF Design

Rs.30,937.29  Rs.24,750.00
Save: 20% off

Add to Cart:
Product Description
This is the ideal solution for long range telemetry or communications.

Two RFD868ux-IND modems with antennas for all antenna ports.

**It requires the PIXH2 to RFD900ux Telemetry Cable - 150/300mm to interface to your application.

The kit consists of:

2 x RFD868ux-IND Radio Modems
1 x Antenna, 900MHz Quarter wave monopole 2.1dBi
1 x Antenna, 900MHz Right Angle Quarter wave monopole 2.1dBi
4 x Antennas, 900MHz Half wave dipole 3dBi
1 x FTDI USB cable
4 x RFD900u antenna cable (RPSMA)
1 x 900ux to 8 way socket cable (900ux) - also suitable for 868ux
1 x PIXH2 to RFD900ux Telemetry Cable 150 mm - also suitable for 868ux

You get a cheaper price when purchasing a whole kit !

Product Description
RFD868ux-IND:

This is the RFD868ux-IND on a double sided mini carrier board. It comes with a mini JST connector and 2x u.Fl RF connectors and heat sink.

**It requires the "ux PIXHAWK2 to RFD900 Telemetry Cable" - 150/300mm to interface to your application.

RFD868ux-IND New Features:

Fully compatible with RFD868x modems.
Air data rate up to: 200kbit/s.
AES Hardware accelerated encryption.
RC PPM Passthrough with telemetry at the same time.
SiK point to point firmware.
Note: Currently due to the bandwidth limitations of the 868 modems Asynchronous Mesh and Multipoint Firmware are not officially supported for the 868X modems and correct operation of this code cannot be guaranteed

Features:
Long range >40km depending on antennas and GCS setup
2 x u.FL RF connectors, diversity switched.
1 Watt (+30dBm) transmit power.
Transmit low pass filter.
> 15dB Low noise amplifier, high IP3.
RX SAW filter.
All I/O ESD protected and filtered.
Re implemented SiK firmware, field upgradable, easy to configure.
Small, light weight.
License free use in India
Interfaces:

RF : 2x u.FL RF connectors
Serial: Logic level TTL (+3.3v)
Power: +5v, ~800mA max peak (at maximum transmit power)
GPIO: General purpose IO (Digital capable).
Specifications:

Frequency Range: 865-869 MHz
Output Power: 1W (+30dBm), controllable in 1dB steps ( +/- 1dB @=20dBm typical )
Air Data transfer rates: 12, 56, 64, 100, 125, 200 kbit/sec (User settable, 200kbit default)*
UART data transfer rates: 1200, 2400, 4800, 9600, 19200, 38400, 57600, 115200, 230400, 460800, 1M baud (User settable, 57600 default)*
*note these values are correct as of version 3.16 SiK firmware

Output Power: 1W (+30dBm) max
Receive Sensitivity: >111 dBm at 12 kbps, 105 at 64kbps and 98 at 200 kbps
Size: 25 mm (wide) x 33 mm (long) x 10.4 mm (thick) - Including RF Shield, PCB and Heatsink.
Weight: 10g
Mounting: Stand alone cable connection
Power Supply: +5 V nominal, (+3.5 V min, +5.5 V max), ~800 mA peak at maximum power
Temp. Range: -40 to +85 deg C
Software / GCS Support:

The software solution is an open source development called "SiK". It has been re implemented to suit the new processor architecture available on the 32bit ARM processor core. A boot loader and interface is available for further development and field upgrade of the modem firmware via the serial port.

Most parameters are configurable via AT commands, Eg. baud rate (air/uart), frequency band, power levels.

Integrated support for configuring the RFD900 radios is supported by APM Planner.

The default settings are at 57600 baud, N, 8, 1, and 200k air data rate.

The RFD868ux manual is here: RFD900ux Manual

The RFD868ux SiK software manual is here : RFD900x Peer-to-peer Manual

Software features include:

Frequency hopping spread spectrum (FHSS)

Transparent serial link

Point to Point

Configuration by simple AT commands for local radio, RT commands for remote radio

User configurable serial data rates and air data rates

Error correction routines, Mavlink protocol framing (user selectable)

Mavlink radio status reporting (Local RSSI, Remote RSSI, Local Noise, Remote Noise)

Automatic antenna diversity switching on a packet basis in real time

Automatic duty cycle throttling based on radio temperature to avoid overheating

Compliance:

The modem is designed to be compliant in India for use in the 865-867Mhz band

This product was added to our catalog on Thursday 16 June, 2022.

Manufacturer Info

Who's Online

There currently are 78 guests online.
Copyright © 2024 RCDhamaka. Powered by RCDhamaka